Phones answered 24/7Everett, WA
Call (833) 490-5225
Guide

River water in the house: the first steps, in order

River water in a Everett home: the order the work goes in, how to tell flood water from supply water, and why the first 48 hours set what can be saved.

Illustration for the guide "River water in the house: the first steps, in order" (Everett, WA)
Short answer

Treat Snohomish River water as contaminated. Keep people and pets out of it, cut power to the wet part of the house if the panel is safe to reach, photograph everything before it moves, then get standing water pumped out. Drying only begins once the water is gone and the dirty material is out.

Key takeaways

  • River flood water is handled as contaminated from the moment it enters, so protective gear and hand washing come before any salvage attempt.
  • Water out, dirty material out, then dry: the order never changes, and running fans over standing water achieves nothing.
  • The Snohomish River crested above 34 feet at Snohomish in December 2025, a record, and a dike and pumping plant failure at French Slough in December 1975 damaged more than 3,000 homes.
  • Soaked carpet pad, batt insulation and the lower band of drywall are normally removed after river water rather than dried in place.
  • Households on a well should assume the water supply is suspect after a flood; a boil-water notice went out to Snohomish County well users in December 2025.
  • Photographs and kept samples of discarded material are worth more to a claim than any description written afterwards.

What is the first thing to do when river water is in the house?

Get out of the water. River water carries whatever it crossed on the way in, so wading through a flooded room in ordinary shoes is the first mistake. Deal with electricity next, and only then think about contents.

If the main panel or the relevant breakers can be reached without standing in water, switch off circuits serving flooded areas. If they cannot, leave them and say so to the first crew that arrives. Submerged outlets, cords and appliances are live hazards, and a plug-in pump run from a wet room is not a solution worth the risk. Gas appliances that have been underwater should be left alone until someone qualified has looked at them.

Then put on boots and gloves before anything else. Everett sits on the delta, and the water that reaches a floor here has run over farmland, roads and in some events a breached dike. Wash hands and forearms after every trip into the wet area, keep children and pets out entirely, and do not eat or drink anything that was sitting in the water. These are unglamorous instructions and they are the ones that get skipped.

How do I tell flood water from a burst pipe, and does it matter?

It matters more than the volume does. Water that arrived over land through a door, a vent or a foundation wall is contaminated. Water from a supply line began clean. The two produce different work and different decisions about what stays.

The giveaway is usually at the entry point: silt lines on exterior walls, debris in a vent well, a tide mark that runs level around the room, mud in the carpet nap. A supply failure leaves a source you can point at and water that is clear at the edges. If the house is on a septic system and the ground is saturated, assume sewage has joined whatever came in, and treat the whole volume accordingly.

Why the distinction drives everything: clean water can often be dried in place, so the job stays small. Contaminated water means porous material that soaked it comes out, gets bagged, and the cavity behind it is cleaned before any drying equipment goes in. A crew that proposes to simply dry a carpet after river water has misread the job. The Snohomish River flood damage page covers how that assessment is made on site.

Why does standing water have to be pumped before anything else?

Because a dehumidifier cannot pull a pond out of a room. Free water is removed mechanically with pumps and extraction units, and only the moisture bound into materials is left for the drying equipment to work on.

The physics is simple and people fight it anyway. Air movers and dehumidifiers work on evaporation from a surface, and while an inch of water sits on the floor the surface is the water, not the building. Every hour spent that way is an hour the subfloor, the base plate and the insulation keep soaking. In a delta house the water may also be being resupplied from the ground outside, so pumping has to keep ahead of the inflow rather than happen once.

In a crawl space the same rule applies underneath you, out of sight. Water trapped on top of a vapor barrier does not drain and does not evaporate out of a vented space in a wet Puget Sound winter. It has to be pumped or vacuumed out and the barrier lifted to see what is beneath. Our page on flood water extraction and pumping describes how discharge is routed so it does not run straight back under the house.

What comes out of the house, and how soon?

Soaked carpet and pad, wet batt insulation, the lower band of drywall where water wicked up, particleboard and laminate that has swollen, and soft contents that sat in the water. The sooner it leaves, the less it contaminates what is staying.

Removal is a decision made material by material. Solid wood, concrete, masonry, tile and metal generally clean and dry. Anything that absorbed dirty water and cannot be cleaned through its whole thickness generally does not. Drywall is cut above the wet line, not at the tide line, because the moisture travels higher inside the board than the stain shows. Insulation behind the cut comes out with it, because wet batt holds water for weeks and loses its purpose anyway.

Do this with a camera in hand. Photograph each room before anything moves, photograph each wall before it is cut, and keep a labeled sample or an offcut of what is being discarded until your insurer has seen the file. That sequence costs nothing and it is the difference between a documented loss and a described one. Drying flood-wet walls and floors goes further into where the cuts land.

How long is the window before mold becomes the second problem?

Days, not weeks, and in a wet Snohomish County winter the clock runs fast. Wet cellulose material in a closed cavity is the main risk, which is why the dirty material comes out and the cavity is opened rather than painted over.

What drives growth is wet organic material plus still air at ordinary indoor temperatures. A flooded wall cavity supplies all three, and closing it up with a new sheet of drywall supplies them permanently. That is the mechanism behind most of the second-round calls after a flood week: the room looked finished and the cavity never dried. The fix is to leave the assembly open until readings say the framing and plates match a dry standard.

Outdoor air is no help here for much of the year. Everett gets around 39 inches of rain in a year, with November and December the wettest months, so throwing the windows open in flood season brings in air that is already close to saturated. Drying has to be done with equipment that condenses the moisture out and dumps it to a drain, and progress is checked with meters rather than by touch. See mold after water damage for what is done when growth has already started.

What about the well, the septic system and drinking water?

Assume both are affected until checked. Snohomish County issued a boil-water notice for well users during the December 2025 flooding. A flooded septic field also stops accepting water, which is its own reason to limit use inside the house.

A well head that has been under flood water can take surface contamination straight down past the casing seal, and the water may look and taste normal afterwards. Follow the guidance your county health district issues, and keep using bottled or boiled water until it says otherwise. Do not assume a filter under the sink has dealt with it; most are not built for that.

On the drain side, a saturated drain field cannot absorb, so water sent down the pipes backs toward the house. Keep laundry and long showers off until the ground has drained and the tank and field have been looked at. Our guide on wells and septic after flooding sets out what to check and in what order, and sewer and septic backup cleanup covers the cleanup if it has already backed up inside.

What does the river's own history say about how fast this happens?

That a delta flood is a dike and drainage event as much as a rainfall one. In December 1975 the river reached 33.16 feet at Snohomish and a dike and pumping plant failure at French Slough damaged more than 3,000 homes. In December 2025 it crested above 34 feet, a record.

The lowland below Everett has been managed by diking districts that began forming by 1910, and the practical consequence for a homeowner is that water arrives by two routes: over a bank, or through a structure that stopped holding. A levee breach near Marysville on Ebey Slough in January 2010 opened a gap about 20 feet across. Water that enters that way comes fast and carries load, and it drains slowly because the land behind the dike is lower than the river.

Across the county, roughly 24,600 people and more than 7,400 houses sit in major-river floodplains, and flood-prone areas see flooding every three to ten years. That is the frequency to plan around rather than treat as freak weather. Households in the lowest ground, including the island and slough areas, have been evacuated in recent events, so an evacuation instruction from county emergency management overrides everything on this page.

When is the right moment to call a crew?

As soon as people are safe and you know water is inside, including while it is still rising. Phones are answered 24/7 and a crew is dispatched as fast as one is available, and the call also fixes the time the response started.

After a countywide event, demand outruns equipment for days; the order calls came in matters. Calling early also means somebody can tell you, over the phone, which of the things you are about to do will damage your own claim, such as hauling wet material to the curb before it has been photographed or running a plug-in pump from a flooded outlet.

Have a few things ready when the crew arrives: where the water came in, how long it has been standing, whether the house is on a well or septic system, whether power is still on in the wet rooms, and where the shutoff and panel are. If a dike or levee failure was involved, say so, because it changes both the contamination assumption and the likely volume still in the ground. You can reach Everett Water Damage Restoration at any hour on (833) 490-5225.

Frequently asked questions

Can I use a shop vacuum and my own fans to get started?

A wet-rated vacuum on a small area is reasonable once power in that area is confirmed safe. Fans are a different matter. They do nothing while free water is still on the floor, and over contaminated water they push whatever is in it around the house. Get the water out first, get the dirty material out second, and let fans be part of a drying plan rather than a reflex.

The water has gone down and the floor looks dry. Is it over?

Almost never. Surfaces dry long before the materials behind them do, and the places that hold water are the base plate, the subfloor, the insulation in the wall and the ground under a crawl space. A meter reading in those places is the only way to know. A floor that feels dry over a wet subfloor is the most common reason a house gets a second, worse call a month later.

Should I throw everything out straight away?

Photograph first, then remove what soaked dirty water. Soft furnishings, mattresses, carpet pad and cardboard that sat in river water are not worth saving. Hard surfaces, metal, solid wood furniture and sealed plastics often clean up. Keep a sample or an offcut of what you discard until your insurer has seen the file, because a list written from memory is weaker evidence than a labeled piece in a bag.

How is a crawl space handled differently from a room?

Water sits on top of the vapor barrier rather than draining, so it has to be pumped or vacuumed out and the barrier lifted to see the soil beneath. Equipment then runs under the floor, not in the room above. Because a vented crawl space exchanges air with a wet Puget Sound winter outside, it dries slowly, and the drying plan usually includes sealing the space off from that outdoor air while it works.

Is flood water in my house covered by my homeowners policy?

Generally not, unless a separate flood policy was bought in advance. The Washington Office of the Insurance Commissioner is clear that typical homeowners policies do not cover flood, while wind-driven rain through a damaged roof or window is often a different matter. That is a question for your own policy and your insurer, not for a crew, and our Washington claims guide explains how the two situations differ.

What if the water came back the next night?

On a river that is still high, or on ground that is still saturated, it can. That is one reason pumping is treated as something that continues rather than a single task, and why a crew will want to know whether the entry point was a door, a vent well or the foundation itself. Until the river drops and the ground drains, drying equipment may be fighting a supply that has not stopped.

Sources

  1. Snohomish County
  2. City of Everett

This guide is general information for Snohomish County homeowners, not a substitute for an on-site inspection. Prices are estimates. See our disclaimer.

Still stuck? We pick up 24/7.

If it's an emergency, call now. For non-urgent help, send the form and we'll call you back.

Keep reading

More guides

WhatsApp